Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R230 Owner's Manual

PDF

Installing the LCD control panel assembly

Prerequisites

CAUTION: : Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Keep the Phillips #2 screwdriver ready.

Steps

  1. Align the tabs on the control panel with the notches on the chassis.
  2. Route the LCD cable through the cable retention clip.
  3. Push the control panel toward the chassis until it snaps into place.
  4. Align and install the LCD control panel board.
  5. Secure the board in place with screws.
    Figure 1. Installing the LCD control panel—four 3.5-inch hot swappable hard drive chassis
    This figure shows installing the LCD control panel—four 3.5-inch hot swappable hard drive chassis.

    1. LCD control panel

    2. notches (6)

    3. display module cable retention clip
    4. display module cable
    5. tabs on the LCD control panel (6)
    Figure 2. Installing the LCD control panel board—four hard drive chassis
    This figure shows installing the LCD control panel board.
    1. screw (2)
    2. control panel connector cable
    3. display module cable
    4. LCD control panel board
    5. USB connector cable
    6. standoff on the chassis (2)

Next steps

Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\