Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge R320 Systems Owner's Manual

Removing The VGA Module

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • NOTE: This procedure applies only to the 8-hard drive system.
  1. If installed, remove the front bezel.
  2. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  3. Open the system.
    • CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking tab on the connector is released before removal and insertion. The locking tab must be engaged after insertion.
  4. Disconnect the display module cable from the control panel board.
  5. Remove the control panel.
  6. Disconnect the VGA module cable from the VGA module.
  7. Using a #2 Philips screwdriver, remove the screw that secures the VGA module to the chassis.
  8. Slide the VGA module out of the chassis.
    Figure 1. Removing and Installing the VGA Module The figure shows removing and installing the VGA module.
    1. control panel
    2. display module cable
    3. screw (top)
    4. VGA module cable
    5. screw (bottom)
    6. VGA module

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\