Dell PowerEdge R330 Owner's Manual

Entering System Setup

Steps

  1. Turn on, or restart your system.
  2. Press F2 immediately after you see the following message:
    F2 = System Setup

    If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart your system and try again.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\