Dell PowerEdge R330 Owner's Manual

Entering the system Service Tag by using System Setup

If Easy Restore fails to restore the Service Tag, use System Setup to enter the Service Tag.

Steps

  1. Turn on the system.
  2. Press F2 to enter System Setup.
  3. Click Service Tag Settings.
  4. Enter the Service Tag.

    NOTE: You can enter the Service Tag only when the Service Tag field is empty. Ensure that you enter the correct Service Tag. After the Service Tag is entered, it cannot be updated or changed.

  5. Click Ok.
  6. Import your new or existing iDRAC Enterprise license.
    For more information, see the Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\