Dell PowerEdge R330 Owner's Manual

Installing a 3.5-inch hard drive blank

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. If installed, remove the front bezel.

Steps

Insert the hard drive blank into the hard drive slot until the release button clicks into place.
Figure 1. Installing a 3.5-inch hard drive blank
This figure shows installing a 3.5-inch hard drive blank
  1. hard drive blank

Next steps

If applicable, install the front bezel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\