Dell PowerEdge R330 Owner's Manual

Installing an (optional) internal SD card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Ensure that the Internal SD Card Port option is set to Enabled in System Setup.
  4. If installed, remove the cooling shroud.

Steps

  1. Locate the SD card connector on the internal dual SD module. Orient the SD card appropriately and insert the contact-pin end of the card into the slot.

    NOTE: The slot is keyed to ensure correct insertion of the card.

  2. Press the card into the card slot to lock it into place.
    Figure 1. Installing internal SD card.
    Figure shows installing internal SD card.
    1. Internal Dual SD module
    2. SD card 1
    3. SD card 2
    4. SD card slot 2
    5. SD card slot 1

Next steps


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\