Dell PowerEdge R330 Owner's Manual

Installing the cooling shroud

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Ensure that you follow the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Align the guide on the cooling shroud with the guide pin on the chassis wall.
  2. Lower the cooling shroud into the chassis until it is firmly seated.
    When firmly seated, the memory socket numbers marked on the cooling shroud align with the respective memory sockets.
    Figure 1. Installing the cooling shroud
    This figure shows installing the cooling shroud.
    1. cooling shroud
    2. guide on the cooling shroud
    3. guide pin on the chassis wall

Next steps

Follow the procedure listed in After working inside your system.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\