Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge R330 Owner's Manual

Installing the LED control panel assembly

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

Steps

  1. For cabled hard drive systems, perform the following steps:
    1. Insert the LED panel into the slot in the chassis.
    2. Secure the LED panel with the screws.
  2. Insert the control panel board into the slot in the chassis and align the two screw holes on the control panel board with the corresponding holes on the chassis.
  3. Secure the control panel board with the screws.
  4. Connect all the cables to the control panel board.
    Figure 1. Installing the LED module—four cabled hard drive chassis
    This figure shows removing and installing the LED module.
    1. LED module
    2. screw (2)
    3. slot on the chassis
    Figure 2. Installing the LED control panel board—four cabled hard drive chassis
    This figure shows installing the control panel board.

Next steps

Follow the procedure listed in the After working inside your system section.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\