Dell PowerEdge R330 Owner's Manual

Installing the optional internal dual SD module

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

    NOTE: Temporarily label each SD card with its corresponding slot before removal.

Steps

  1. Locate the internal dual SD module (IDSDM) connector on the system board. To locate the IDSDM connector, see the System board connectors section.
  2. Align the IDSDM with the connector on the system board.
  3. Push the IDSDM until it is firmly seated on the system board.
    Figure 1. Installing the optional internal dual SD module
    The figure shows installing the optional internal dual SD module.
    1. IDSDM
    2. pull tab
    3. IDSDM connector

Next steps

  1. Install the SD cards.

    NOTE: Re-install the SD cards into the same slots based on the labels you had marked on the cards during removal.

  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\