Dell PowerEdge R330 Owner's Manual

Removing a 3.5-inch hard drive adapter from a 3.5-inch hot swappable hard drive carrier

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Keep the Phillips #2 screwdriver ready.
  3. Remove the 3.5-inch hot swappable hard drive carrier from the system.

Steps

  1. Remove the screws from the rails on the 3.5-inch hot swappable hard drive carrier.
  2. Lift the 3.5-inch hard drive adapter out of the 3.5-inch hot swappable hard drive carrier.
    Figure 1. Removing a 3.5 inch hard drive adapter from a hard drive carrier.
    This figure shows removing a 3.5 inch hard drive adapter from a hard drive carrier.
    1. 3.5-inch hot swappable hard drive carrier
    2. screw (5)
    3. 3.5-inch hard drive adapter
    4. 2.5-inch hot swappable hard drive

Next steps

Remove the 2.5-inch hot swappable hard drive from a 3.5-inch hard drive adapter.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\