Dell PowerEdge R330 Owner's Manual

Removing an (optional) internal SD card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the cooling shroud.

Steps

  1. Locate the SD card slot on the internal dual SD module and press the card to release it from the slot.

    NOTE: Temporarily label each SD card with its corresponding slot number before removal. Re-install the SD card(s) into the corresponding slots.

  2. Lift the SD card away from the internal dual SD module.
    Figure 1. Removing internal SD card.
    Figure shows removing internal SD card.
    1. Internal Dual SD module
    2. SD card 1
    3. SD card 2
    4. SD card slot 2
    5. SD card slot 1

Next steps

  1. Install an internal SD card.
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\