Dell PowerEdge R330 Owner's Manual

Removing the system cover

Prerequisites

  1. Ensure that you follow the Safety instructions.
  2. Turn off the system, including any attached peripherals.
  3. Disconnect the system from the electrical outlet and peripherals.
  4. If installed, remove the front bezel.

Steps

  1. Turn the latch release lock to the unlock position.
  2. Lift the latch and rotate the latch toward the back of the system.
    The system cover slides back, disengaging the tabs on the system cover from the slots on the chassis.
  3. Hold the cover on both sides, and lift the cover away from the system.
    Figure 1. Removing the system cover
    This figure shows removing the system cover.
    1. latch release lock
    2. latch
    3. system cover

Next steps

Install the system cover.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\