Dell PowerEdge R330 Owner's Manual

Replacing the optional internal USB memory key

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the expansion card riser.

Steps

  1. Locate the USB port or USB memory key on the system board.
    To locate the USB port, see the System board jumpers and connectors section.
  2. If installed, remove the USB memory key from the USB port.
    Figure 1. Removing the internal USB memory key
    This figure shows removing the internal USB memory key.
    1. USB memory key
    2. USB port
  3. Insert the replacement USB memory key into the USB port.
    Figure 2. Installing the internal USB memory key
    This figure shows installing the internal USB memory key
    1. USB memory key
    2. USB port

Next steps

  1. Install the expansion card riser.
  2. Follow the procedure listed in the After working inside your system section.
  3. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\