Dell PowerEdge R330 Owner's Manual

Running the Embedded System Diagnostics from the Dell Lifecycle Controller


  1. As the system boots, press F10.
  2. Select Hardware Diagnostics Run Hardware Diagnostics.
    The ePSA Pre-boot System Assessment window is displayed, listing all devices detected in the system. The diagnostics starts executing the tests on all the detected devices.

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\