Dell PowerEdge R330 Owner's Manual

Setting up your system

Complete the following steps to set up your system:

Steps

  1. Unpack the system.
  2. Install the system into the rack. For more information about installing the system into the rack, see your system Rack Installation Placemat at Dell.com/poweredgemanuals.
  3. Connect the peripherals to the system.
  4. Connect the system to its electrical outlet.
  5. Turn the system on by pressing the power button or by using iDRAC.
  6. Turn on the attached peripherals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\