Dell PowerEdge R360 Installation and Service Manual

PDF

BOSS-N1 module kit

The BOSS-N1 module supports up to two M.2 NVMe SSDs.

Before you begin the installation or removal process, follow the safety guidelines and before working inside the system instructions.

Table 1. BOSS-N1 module kit componentsThe table describes the components in the BOSS-N1 module kit.
Components in kit R360 (quantity)
BOSS-N1 controller card module 1
BOSS-N1 card carrier 1 or 2*
M.2 NVMe SSD 1 or 2*
M.2 NVMe SSD capacity label 1 or 2†
BOSS-N1 card carrier blank 1
M3 x 0.5 x 4.5 mm screws 1
BOSS-N1 signal cable for mother board (270 mm) 1
BOSS-N1 power cable for mother board (305 mm) 1
NOTE:*The quantity depends on the purchase order.
NOTE:†The quantity depends on the BOSS-N1 card carrier.

To remove the BOSS blank :

  1. Power off the system
  2. Pull the BOSS N1 blank out of the system to remove it.
Figure 1. Removing the BOSS-N1 module blank
his image shows removing the BOSS-N1 module blank
Figure 2. Installing the BOSS-N1 module blank
This image shows Installing the BOSS-N1 module blank

To install the BOSS-N1 module:

  1. To install the BOSS-N1 module , see Install the BOSS N1 module .
NOTE:Refer to cable routing section for BOSS N1 cable connections.
NOTE:Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only required when installing the BOSS-N1 controller card module.
NOTE:BOSS N1 module cannot be installed if the system has an internal adapter PERC card installed.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\