Dell PowerEdge R360 Installation and Service Manual

Filter bezel kit

Prerequisites

The filter bezel kit and replacement filter media kit are available for the Customer. Depending on the kit ordered, the respective components are available.

Table 1. Components in the filter bezel kitThe table describes the components in the filter bezel kit.
Components	Filter Bezel kit
Components	Details	Quantity
Filter Bezel	Filter Bezel	1
Filter Media	Filter Media	1

Table 2. Components in the replacement filter media kitThe table describes the components in the replacement filter medial kit.
Components	Filter Bezel kit
Components	Details	Quantity
Filter Media	Filter Media	4

NOTE:To maintain optimal system health, Dell Technologies recommends checking and changing the filter media every 3-6 months. Filter media can be ordered from Dell.

Before you begin, follow the safety guidelines and before working inside the system instructions.

Steps

If installed, remove the security bezel and keep it safe.
Loosen and remove the two screws to take out the bracket from the filter bezel.
Insert the filter media.
Replace the bracket and tighten the two screws to secure it in place.
Insert the right side of the filter bezel in to the grove on the system.
Press the button on the left side of the filter bezel and install it on the system.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 1. Installing the filter
Figure 2. Installing the filter bezel

Next steps

After installing, follow the After working inside the system instructions.

Dell PowerEdge R360 Installation and Service Manual

Filter bezel kit

Prerequisites

Steps

Next steps

Rate this content