Dell PowerEdge R360 Installation and Service Manual

PDF

Installing a 2.5-inch drive into a 3.5-inch drive adapter

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.

Steps

  1. Align the screw holes on the 2.5-inch drive with the screw holes on the 3.5-inch drive adapter.
  2. Using a Phillips #2 screwdriver, secure the 2.5-inch drive to the 3.5-inch drive adapter.
    NOTE: If the 2.5-inch drive has a Torx screw, use Torx 6 screwdriver to install the drive to a 3.5-inch drive adapter.This image shows Torx screwdriver
    Figure 1. Installing a 2.5-inch drive into a 3.5-inch drive adapter
    This image shows how to install a 2.5 inch drive into a 3.5 inch drive adapter

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\