Dell PowerEdge R360 Installation and Service Manual

PDF

Installing a drive into the drive carrier

Prerequisites

CAUTION:Mixing drive carriers from other generations of PowerEdge servers is not supported.

Steps

  1. Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.
  2. Align the screw holes on the drive with the screw holes on the drive carrier.
  3. Using a Phillips #1 screwdriver, replace the screws to secure the drive to the drive carrier.
    NOTE:If the hard drive or SSD carrier has a Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to install the drive.This image shows Torx screwdriver
    Figure 1. Installing a drive into the drive carrier
    This image shows how to install a drive into the drive carrier.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\