Dell PowerEdge R360 Installation and Service Manual

PDF

Installing an expansion card riser

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove air shroud.

Steps

  1. Hold the riser by the blue touch points and align it to the connector and the guide pin on the system.
  2. Lower the riser into place till its firmly seated on the connector.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the riser
    This image shows how to install the riser.

Next steps

  1. Install the air shroud.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\