Dell PowerEdge R360 Installation and Service Manual

PDF

Installing the air shroud

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove the system cover.

Steps

  1. Align the air shroud with the standoff on the chassis wall.
    NOTE:Route the cable properly to prevent the cable from being pinched or crimped.
  2. Lower the air shroud into the system until it is firmly seated.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing air shroud
    This image shows how to install air shroud.

Next steps

  1. Install the system cover.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\