Dell PowerEdge R360 Installation and Service Manual

PDF

Installing the BOSS N1 module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove system cover.
  4. Remove air shroud.
  5. Remove the BOSS N1 blank.

Steps

  1. Insert the BOSS N1 card in to the cage.
  2. Tighten the two screws to secure the BOSS N1 card to the cage.
    Figure 1. Installing the BOSS N1 card
    This image shows how to install the BOSS N1 card.
  3. Ailing the BOSS N1 cage with the unlock sign and slide back into the bay till it locks firmly in place.
  4. Tighten the screw to secure the BOSS N1 cage to the chassis.
  5. Connect the cables to the BOSS N1 module.
    Figure 2. Installing the BOSS N1 cage
    This image shows how to install the BOSS N1 cage
  6. Slide the BOSS N1 M.2 carrier in to the slot.
  7. Close the latch to secure the BOSS N1 M.2 carrier .
    Figure 3. Installing the BOSS N1 M.2 module
    This image shows how to install the M.2 BOSS card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\