Dell PowerEdge R360 Installation and Service Manual

PDF

Installing the internal PERC card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove air shroud.
  4. Remove the expansion card riser (if installed).

Steps

  1. Hold the PERC card by the metal holder and align the connector to the slot on the system board.
  2. Slide the PERC card into the slot till its firmly seated.
  3. Install and tighten the two screws to secure the PERC card.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the internal PERC card
    This image shows how to install the internal PERC card

Next steps

  1. Install the expansion card riser(if removed).
  2. Install the air shroud.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\