Dell PowerEdge R360 Installation and Service Manual

PDF

Installing the right control panel

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove air shroud.

Steps

  1. Align and slide the right control panel into the slot on the system.
  2. Route the right control panel cable through the side wall of the system.
    NOTE:Route the cable properly to prevent the cable from being pinched or crimped.
  3. Connect the right control panel cable to the connector on the system board.
  4. Using the screwdriver, tighten the two screws that secure the right control panel to the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the right control panel
    This image shows Installing the right control panel.

Next steps

  1. Install the air shroud .
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\