Dell PowerEdge R360 Installation and Service Manual

PDF

PowerEdge R360 system overview

The PowerEdge R360 system is a 1U server that supports:
  • One Intel® Xeon® 6300 series processor or one Intel® Xeon® E-2400 series processor with up to eight cores or one Intel® Pentium® processor with two cores
  • Four DIMM slots
  • Two redundant AC or DC power supply units
  • Up to:
    • 8 x 2.5 inch SAS/SATA (HDD/SSD) drives
    • Up to 4 x 3.5 inch SAS/SATA (HDD/SSD) drives
    • Up to 4 x 2.5 inch SAS/SATA (HDD/SSD) drives with 3.5 inch to 2.5-inch adapter in 3.5-inch carrier
    • Up to 6 x 2.5-inch hot-swappable SAS/SATA drives through PERC + 2 x 2.5-inch direct attach NVMe drives
NOTE:All instances of SAS, SATA drives are referred to as drives in this document, unless specified otherwise.
NOTE:The Dell PowerEdge R360 system supports speeds of 12 Gbps for SAS3 and 6 Gbps for SATA. The drive speed is determined by the controller's capability.
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the system warranty.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\