Dell PowerEdge R360 Installation and Service Manual

PDF

Removing a 2.5-inch drive from a 3.5-inch drive adapter

Prerequisites

NOTE:A 2.5-inch drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch drive carrier.

Steps

  1. Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
    NOTE: If the 2.5-inch drive has a Torx screw, use Torx 6 screwdriver to remove the drive from a 3.5-inch drive adapter.This image shows Torx screwdriver
  2. Remove the 2.5-inch drive from the 3.5-inch drive adapter.
    Figure 1. Removing a 2.5 inch drive from a 3.5-inch drive adapter
    This image shows how to remove a 2.5 inch drive from a 3.5 inch drive adapter

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\