Dell PowerEdge R360 Installation and Service Manual

PDF

Removing the BOSS N1 blank

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove system cover.
  4. Remove air shroud.

Steps

Pull the N1 BOSS blank out of the system to remove it.
Figure 1. Removing the BOSS N1 blank
This image shows how to remove the N1 BOSS blank.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\