Dell PowerEdge R360 Installation and Service Manual

PDF

Removing the BOSS N1 module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove air shroud.

Steps

  1. Disconnect the cables from the BOSS N1 module.
  2. Lift the retention latch to unlock the BOSS N1 M.2 module.
  3. Pull the BOSS N1 M.2 module out from the rear of the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the BOSS N1 M.2 module
    This image shows how to remove the BOSS M.2 module
  4. Loosen and remove the single screw securing the BOSS N1 cage t the chassis floor.
  5. Slide the BOSS N1 cage to the unlock position and lift from the system to remove.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 2. Removing the BOSS N1 cage
    This image shows how to remove the BOSS N1 cage
  6. Loosen and remove the two screws securing the BOSS N1 card to the cage.
  7. Pull the BOSS N1 card out from the cage.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 3. Removing the BOSS N1 card
    This image shows how to remove the BOSS N1 card

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\