Dell PowerEdge R360 Installation and Service Manual

PDF

Removing the cooling fan

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove air shroud.

Steps

  1. Press the release tabs on the fan cable connector and disconnect the cable from the system board.
  2. Lift the cooling fan from the cooling fan cage.
    Figure 1. Removing cooling fan
    This image shows how to remove the cooling fan.

Next steps

  1. Install the cooling fan.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\