Dell PowerEdge R360 Installation and Service Manual

PDF

Removing the front bezel

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. If installed, remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at PowerEdge manuals.
  4. Keep the bezel key handy.
    NOTE:The bezel key is part of the LCD bezel package.

Steps

  1. Unlock the bezel.
  2. Press the release button, and disengage the left end of the bezel.
  3. Unhook the right end, and remove the bezel.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the front bezel
    This image shows how to remove the front bezel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\