Dell PowerEdge R360 Installation and Service Manual

PDF

Removing the internal PERC card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove air shroud.
  4. Remove the expansion card riser (if installed).

Steps

  1. Loosen and remove the two screws securing the PERC card.
  2. Hold the metal holder, slide the PERC card towards the PSU to remove it from the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the internal PERC card
    This image shows how to remove the internal PERC card

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\