Dell PowerEdge R360 Installation and Service Manual

PDF

Removing the intrusion switch

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove air shroud.

Steps

  1. Disconnect and remove the intrusion switch cable from the system board.
    NOTE:Observe the routing of the cable as you remove it from the system. Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
  2. Loosen and remove the single screw to remove the intrusion switch from the chassis.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the intrusion switch
    This image shows how to remove the intrusion switch.

Next steps

  1. Install the intrusion switch.
  2. Follow the procedure listed in After working inside your system.
.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\