Dell PowerEdge R360 Installation and Service Manual

PDF

Removing the left control panel

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove system cover.
  4. Remove air shroud.

Steps

  1. Disconnect the control panel cable from the connector on the system board.
  2. Using the screwdriver, remove the three screws that secure the left control panel the system.
  3. Holding the control panel , slide the left control panel out of the system.
    NOTE:Observe the routing of the cable as you remove the left control panel from the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the left control panel
    This image shows Removing the left control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\