Dell PowerEdge R360 Installation and Service Manual

PDF

Removing the right control panel

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove air shroud.

Steps

  1. Disconnect the right control panel cable on the system board.
    NOTE:Observe the routing of the cable assembly as you remove the right control panel from the system.
  2. Using the screwdriver, remove the two screws that secure the right control panel to the system.
  3. Holding the right control panel and cable assembly, slide the right control panel out of the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the right control panel
    This image shows how to remove the right control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\