Dell PowerEdge R360 Installation and Service Manual

PDF

Replacing the system battery

Prerequisites

WARNING:There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type that is recommended by the manufacturer. For more information, see the safety information that shipped with your system.
  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working on your system.
  3. Remove air shroud.
  4. Remove expansion card riser(if installed).

Steps

  1. Press and hold the battery socket retention latch, for the battery to pop out. .
    CAUTION:To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery.
    NOTE: If the battery does not pop out, then lift it out of the socket.
    Figure 1. Removing the system battery
    This image shows how to remove the system battery.
  2. To install a new system battery, hold the battery with the positive side facing up and slide it under the socket battery latch.
  3. Press the battery into the connector until it snaps into place.
    Figure 2. Installing the system battery
    This image shows how to install the system battery.

Next steps

  1. Install the expansion card riser(if removed).
  2. Install the air shroud.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\