Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R440 Installation and Service Manual

PDF

Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. If installed, remove the front bezel.
  3. Remove the 3.5-inch drive carrier from the system.

Steps

  1. Using a Phillips #1 screwdriver, remove the screws from the rails on the drive carrier.
    NOTE If the 3.5-inch drive has Torx screw, use Torx 6 screwdriver to remove the drive from a 3.5-inch drive adapter.
  2. Lift the 3.5-inch drive adapter out of the 3.5-inch drive carrier.
    Figure 1. Removing a 3.5 inch drive adapter from a 3.5-inch drive carrier
    The image shows removing a 2.5-inch drive adapter from a 3.5-inch drive carrier

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\