Dell PowerEdge R520 Owner's Manual

Removing The Optical Drive

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

If installed, remove the front bezel.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
Open the system.
Disconnect the power/data cable from the back of the optical drive. Note the routing of the power/data cable on the side on the system as you remove them from the system board and drive. You must route these cables properly when you replace them to prevent them from being pinched or crimped.
To remove the optical drive, press down and push the blue release tab toward the front of the system.
Slide the optical drive out of the system until it is free of the drive bay.
If you are not adding a new optical drive, install the optical drive blank.
Close the system.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
If applicable, install the front bezel.
Figure 1. Removing and Installing the Optical Drive
1. optical drive
2. power and data cable
3. release tab