Dell PowerEdge R530xd Owner's Manual

PDF

Installing a hard-drive adapter into a hard-drive carrier

Prerequisites

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Ensure that you read the Safety instructions.
  2. Keep the #2 Phillips screwdriver ready.

Steps

  1. Insert the hard-drive adapter into the hard-drive carrier with the connector end of the hard drive toward the back of the hard-drive carrier.
  2. Align the screw holes on the hard drive with the holes on the hard-drive carrier.
  3. Install the screws to secure the hard drive to the hard-drive carrier.
    Figure 1. Removing and installing a hard-drive adapter into a 3.5 inch hard-drive carrier This figure shows removing and installing a hard-drive adapter into a 3.5 inch hard-drive carrier.
    1. 3.5 inch hard-drive carrier
    2. screw (5)
    3. hard-drive adapter
    4. 2.5 inch hard drive

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\