Dell PowerEdge R530xd Owner's Manual

PDF

Installing an internal SD card

Prerequisites

  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system .
  3. If connected, disconnect the cables from expansion card (s).
  4. If installed, remove the expansion card riser (s).
    • NOTE: If open, close the expansion card latch on the cooling shroud to release the full length card.
  5. Remove the cooling shroud.
  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • NOTE: To use an SD card with your system, ensure that the Internal SD Card Port is enabled in the System Setup.

Steps

  1. Locate the SD card connector on the internal dual SD module. Align the SD card appropriately and insert the contact-pin end of the card into the slot.
    • NOTE: The slot is keyed to ensure correct insertion of the card.
  2. Press the card into the card slot to lock it into place.
  1. If removed, reinstall the PCIe expansion card riser (s).
  2. If disconnected, connect the required power or data cables to the expansion card(s).
  3. Reinstall the cooling shroud.
  4. If required, open the expansion card latch on the cooling shroud to support the full length expansion card.
  5. Follow the procedure listed in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\