Dell PowerEdge R530xd Owner's Manual

PDF

Installing the cooling shroud

Prerequisites

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • NOTE: For proper seating of the cooling shroud in the chassis, ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing bracket.
  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system .

Steps

  1. Align the tabs on the cooling shroud with the securing holes at the back of the chassis.
  2. Lower the cooling shroud into the chassis until it is firmly seated.
  1. Install the optional PCIe expansion card riser.
  2. If disconnected, reconnect thecables to the expansion card(s).
  3. If required, open the expansion-card latch on the cooling shroud to support the full length expansion card.
  4. Follow the procedure listed in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\