Dell PowerEdge R530xd Owner's Manual

PDF

Installing the I/O panel

Prerequisites

  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system .
  3. Keep the T15 Torx screwdriver ready.
  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

Steps

  1. Fold the PPID label around the cable.
  2. Push the cable until the cable passes completely through the channel.
    • CAUTION: To prevent damage to the I/O cable, you must release the locking tab before removing or installing the I/O cable from the connector on the hard-drive backplane.
  3. If locked, rotate the locking tab on the I/O cable connector clockwise 90 degrees to release the lock.
  4. Connect the I/O panel cable to the connector on the hard-drive backplane.
  5. Rotate the locking tab on the I/O cable connector counter clockwise 90 degrees to secure the lock.
  6. Tighten the screws to secure the control panel to the chassis.
    • NOTE: You must route the cable properly to prevent it from being pinched or crimped.

Follow the procedure listed in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\