Dell PowerEdge R530xd Owner's Manual

PDF

Installing the (optional) 2.5 inch internal hard drive carrier

Prerequisites

  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system .
  3. If applicable, disconnect the power or data cables from expansion card (s).
  4. If required, remove the PCIe expansion card riser.
    • NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full length card.
  5. Remove the cooling shroud.

Steps

  1. Align the internal hard drive carrier with the guide pins to the slot on the internal hard drive cage.
  2. Insert the internal hard drive carrier into the internal hard drive cage and press the handle-lock down to the lock position.
  1. Reconnect the power and data cables to the internal hard drives.
  2. If removed, reinstall the PCIe expansion card riser.
  3. If disconnected, reconnect the cables to the expansion card(s).
  4. Reinstall the cooling shroud.
  5. If required, open the expansion card latch on the cooling shroud to support the full length expansion card.
  6. Follow the procedure listed in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\