Dell PowerEdge R530xd Owner's Manual
Installing the power interposer board
Prerequisites
- CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
- Ensure that you read the Safety instructions.
- Follow the procedure listed in Before working inside your system .
- Remove the cooling shroud.
- If applicable, disconnect the power or data cables from expansion card (s).
- If applicable, remove the expansion card riser
- Remove the internal hard drive carrier.
- Remove the internal hard drive cage.
Steps
- Align the locking slots on the power interposer board with the hooks on the power supply cage and slide it into place.
- Route the power cables as applicable, and connect the power cables to the system board and hard drive backplane.
- Install the power supply module(s) in their original locations.
- If applicable, install the PCIe expansion card riser.
- If applicable, connect the required power or data cables to the expansion card(s).
- Install the internal hard drive cage.
- Install the internal hard drive carrier.
- Reinstall the cooling shroud.
- If applicable open the expansion card latch on the cooling shroud to secure the full length expansion card.
- Follow the procedure listed in After working inside your system .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\