Dell PowerEdge R530xd Owner's Manual

PDF

Removing a DC power supply unit

Prerequisites

  • WARNING: For equipment using –(48–60) V DC power supplies, a qualified electrician must perform all connections to DC power and to safety grounds. Do not attempt connecting to DC power or installing grounds yourself. All electrical wiring must comply with applicable local or national codes and practices. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow all safety instructions that came with the product.
  • CAUTION: The system requires one power supply for normal operation. On power-redundant systems, remove and replace only one power supply at a time in a system that is powered on.
  • NOTE: You may have to unlatch and lift the optional cable management arm if it interferes with power supply removal. For information about the cable management arm, see the system’s rack documentation.
  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system .

Steps

  1. Disconnect the power wires from the power source and the connector from the power supply you intend to remove.
  2. Disconnect the safety ground wire.
  3. Press the release latch and slide the power supply out of the chassis.
    Figure 1. Removing and installing a DC power supply This figure shows removal and installation of a DC power supply.
    1. release latch
    2. power supply status indicator
    3. power supply
    4. connector
    5. power supply handle

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\