
Dell PowerEdge R530xd Owner's Manual
Removing a heat sink
Prerequisites
- CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
- NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.
- CAUTION: Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is necessary to maintain proper thermal conditions.
- NOTE: To ensure proper system cooling, you must install a processor blank in any empty processor socket.
- Ensure that you read the Safety instructions.
- Follow the procedure listed in Before working inside your system .
- If connected, disconnect the cables from expansion card (s).
- If required, remove the PCIe expansion card riser.
- Remove the cooling shroud.
Keep the Phillips #2 screwdriver ready.
Steps
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
