Dell PowerEdge R530xd Owner's Manual

PDF

Removing an AC power supply unit

Prerequisites

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • CAUTION: The system requires one power supply for normal operation. On power-redundant systems, remove and replace only one power supply at a time in a system that is powered on.
  • NOTE: You may have to unlatch and lift the optional cable management arm if it interferes with power supply removal. For information about the cable management arm, see the system’s rack documentation.
  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system .

Steps

  1. Disconnect the power cable from the power source and from the power supply unit that you intend to remove and remove the cables from the strap.
  2. Press the release latch and slide the power supply unit out of the chassis.
    Figure 1. Removing and installing an AC power supply unit This figure shows removing and installing an AC power supply unit.
    1. release latch
    2. power supply unit cable connector
    3. power supply unit
    4. connector
    5. power supply unit handle
  1. Install the AC power supply unit.
  2. Follow the procedure listed in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\