Dell PowerEdge R530xd Owner's Manual

PDF

Removing the internal dual SD module

Prerequisites

  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system .
  3. Remove the cooling shroud.
    • NOTE: If applicable, close the expansion-card latch on the cooling shroud to release the full length card.
  4. If applicable, disconnect the power or data cables from expansion card (s).
  5. If applicable, remove the expansion-card riser (s).
  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

Steps

  1. Locate the internal dual SD module on the system board.
  2. If installed, remove the SD card(s).
  3. Hold the plastic pull tab and pull the dual SD module out of the system board.
    Figure 1. Removing and installing the Internal Dual SD Module (IDSDM) This figure shows removing and installing the internal dual SD card module.
    1. Internal Dual SD module
    2. LED status indicator (2)
    3. SD card (2)
    4. SD card slot 2
    5. SD card slot 1
    6. IDSDM connector

    The following table describes the IDSDM indicator codes.

    ConventionIDSDM indicator code Condition
    AGreenIndicates that the card is online
    BFlashing greenIndicates rebuild or activity
    CFlashing amberIndicates a card mismatch or a card failure
    DAmberIndicates that the card is offline, has failed, or is write-protected
    ENot litIndicates that the card is either missing or booting
  1. If removed, reinstall the PCIe expansion card riser (s).
  2. If disconnected, connect the cables to the expansion card(s).
  3. Reinstall the cooling shroud.
  4. If required open the expansion card latch on the cooling shroud to support the full length expansion card.
  5. Follow the procedure listed in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\