Dell PowerEdge R530xd Owner's Manual

PDF

Removing the I/O panel

Prerequisites

  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system .
  3. Keep the T15 Torx screwdriver ready.
  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • CAUTION: The I/O module is connected to the backplane using a Zero Insertion Force(ZIF) connector. To prevent damage to the I/O cable, you must release the locking tab of the ZIF connector on the hard drive backplane before removing or installing the I/O cable. Do not use excessive force when removing the I/O module cable as it can damage the connectors.

Steps

  1. Lift the locking tab on the I/O cable connector to release the lock.
  2. Disconnect the I/O cable from the backplane.
  3. Remove the screws securing the I/O panel to the chassis.
  4. Pull out the I/O panel cable through the channel on the chassis.
    Figure 1. Removing and installing the I/O panel This figure show the removing and installing the I/O panel
    1. I/O panel cable connector
    2. ZIF connector on the hard drive backplane
    3. I/O panel cable
    4. hard drive backplane
    5. screw (3)
    6. I/O panel
    7. chassis
  1. Replace the I/O panel. See #GUID-F29F2AF7-CFF0-4563-89A1-F6DC49AD8670.
  2. Follow the procedure listed in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\