Dell EMC PowerEdge R550 Installation and Service Manual

PDF

Installing the IDSDM module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.

Steps

  1. Locate the IDSDM connector on the system board.
  2. Align IDSDM module with the connector on the system board.
  3. Press the IDSDM module, until firmly seated on the system board connector.
    Figure 1. Installing the IDSDM module
    This image show shows the installation of the iDSDM module.

Next steps

  1. Install the MicroSD cards.
    NOTE:Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
  2. Follow the procedure listed in the After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\