Dell EMC PowerEdge R550 Installation and Service Manual

PDF

Installing a power supply unit blank

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
    NOTE:Install the power supply unit (PSU) blank only in the second PSU bay.
  2. Remove the PSU.

Steps

Align the PSU blank with the PSU bay and push it into the PSU bay until it clicks into place.
Figure 1. Installing a power supply unit blank
This image shows how to install a power supply unit blank.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\